/pics/aquariums/jumpguard1.png
Zoom image

D-D Jumpguard DIY Aquarium Cover - 180cm x 90cm (72" x 36")


Not rated yet
Out of stock

There is nothing worse than coming down in the morning to finding your favorite fish lying dead and crispy on the carpet.

Many fish, especially wrasse, have a tendency to jump from the tank when frightened or chased by another fish and so a solution to preventing the loss of such fish should be high on every fish keepers priority list.

D-D Jumpguard covers are avery lightweight, sleek, low visual impact and easy to construct screen cover suitable for most aquarium types, specifically designed to prevent fish loss due to jumping whilst maintaining high light penetration.

  • $65.00
You will earn up to 487 reward points after purchasing this product.
Add a different product to compare

Jumpguard DIY Aquarium Cover

There is nothing worse than coming down in the morning to finding your favorite fish lying dead and crispy on the carpet.

Many fish, especially wrasse, have a tendency to jump from the tank when frightened or chased by another fish and so a solution to preventing the loss of such fish should be high on every fish keepers priority list.

D-D Jumpguard covers are avery lightweight, sleek, low visual impact and easy to construct screen cover suitable for most aquarium types, specifically designed to prevent fish loss due to jumping whilst maintaining high light penetration.

jumpguard2.png

Available in the following versions and are designed to be cut to size:

  • TC7575-75cm x 75cm nominal size.
  • TC12075- 120cm x 75cmnominal size.
  • TC18075- 180cm x 90cmnominal size.

Notes:

  1. The maximum size frame that can be made from each kit will be 3.6cm longer than stated in each direction.
  2. The tank should be measured from inside face of glass to inside face of glass.

 

jumpguard3.png

 

Included in the kit

TheJumpguard Aquarium Coveris a kit of parts which allows the aquarist to create a custom frame for their specific aquarium.The rigid corners and extruded aluminum sectioncreate a very solid frame whichsits neatly inside glass of the aquarium glass, resting onthe top lip.


Kit Contents:

  • 4 x Aluminum frame sections
  • 4 x Plastic corners
  • 2 x Plastic handles
  • 1 x Length of rubber spline
  • 1 x Sheet of clear mesh
  • 1 x Spline roller tool
  • 1 x Instruction manual
  • 1 x Brace bar set (currently TC18075 model only)

 

Features of the NEW Jumpguard Tank Cover

jumpguard4.png

 

NEW PROFILE DESIGN
The special extruded aluminum profile is now shaped with a lip which sits directly onto the edge of the glass, removing the requirement for any additional clips or brackets. The section is extruded then powder coated in a tough, low sheen, black finish for greater scratch resistance and greater aesthetics.

 

jumpguard5.png

 

IMPROVED CORNER MOULDINGS
The lower section of the corners is specifically designed so that it does not interfere with the silicone bead in the corners of your tank which gives a tight fit to the glass with no gaps. It also makes it easier and neater to cut off the corner if you want to bring wires out at the back of the tank for pumps and heaters.

 

jumpguard6.png

MAXIMUM LIGHT PENETRATION
For those concerned with loss of light penetration into your reef tanks, we tested light levels with a Apogee MQ-200 meter and got the following results:
PAR without cover around 390 - 400 PAR with cover around 380 - 390 Approximately a 2.5% reduction in light with no shadowing at all.

 

D-D & Ecotech discus the merits of JumpGuard tank covers on your aquarium


 

JumpGuard Installation